2-4
View
User view
Parameters
remote-system: IPv6 address or host name (a string a 1 to 46 characters) of the destination device.
-i interface-type interface-number: Specifies the type and number of an interface. This argument takes
effect only when the address of the TFTP server is a link-local address and the specified outgoing
interface has a link-local address.
get: Specifies to download a file.
put: Specifies to upload a file.
source-filename: Specifies the name of a source file with a string of 1 to 64 letters.
destination-filename: Specifies the name of a destination file with a string of 1 to 64 letters. If no such
parameters are specified, then the destination file’s name will be the same as the source file’s.
Description
Use the tftp ipv6 command to perform the following operations:
z Download a file: Download a specified source file from TFTP server to local.
z Upload a file: Upload a specified source file from local to TFTP server.
Examples
# Download a file from TFTP server.
<Sysname> tftp ipv6 fe80::250:daff:fe91:e058 -i Vlan-interface 300 get filetoget
.
File will be transferred in binary mode
Downloading file from remote tftp server, please wait..... received: 4469 bytes in 1.243
seconds.
tracert ipv6
Syntax
tracert ipv6 [ -f first-ttl | -m max-ttl | -p port | -q packet-num | -w timeout ]* remote-system
View
Any view
Parameters
-f first-ttl: Specifies the first TTL, that is, the allowed number of hops for the first packet. Ranges from 1
to 255, defaults to 1, and must be less than the maximum TTL.
-m max-ttl: Specifies the maximum TTL, that is, the maximum allowed number of hops for a packet. The
value ranges from 1 to 255, defaults to 30. It must be greater than the first TTL.
-p port: Specifies the port number of the destination UDP, ranging from 1 to 65535, with the default of
33434.
-q packet-num: Specifies the maximum number of packets sent to a hop, ranging from 1 to 65535, with
the default of 3.
To Next Page
Loading...
Need help?
General