1-6
Description
Use the display ntdp command to display the global NTDP information.
The displayed information includes topology collection range (hop count), topology collection interval
(NTDP timer), device/port forwarding delay of topology collection requests, and time used by the last
topology collection.
Examples
# Display the global NTDP information.
<Sysname> display ntdp
NTDP is running.
Hops : 4
Timer : 0 min(disable)
Hop Delay : 100 ms
Port Delay: 10 ms
Last collection total time: 92ms
Table 1-2 Description on the fields of the display ntdp command
Field Description
NTDP is running. NTDP is enabled globally on this device.
Hops
Hop count for topology collection, which is configured through
the ntdp hop command
Timer
Interval to collect topology information, which is configured
through the ntdp timer command
"disable" means this switch is not a management device and
does not perform periodic topology collection.
Hop Delay
Delay for other devices to forward topology collection requests,
which is configured through the ntdp timer hop-delay
command
Port Delay
Delay for ports on other devices to forward topology collection
requests, which is configured through the ntdp timer
port-delay command
Last collection total time Time used by the last topology collection
display ntdp device-list
Syntax
display ntdp device-list [ verbose ]
View
Any view
Parameters
verbose: Displays the detailed information of devices in a cluster.
To Next Page
Loading...
Need help?
General