3-14
rip metricin
Syntax
rip metricin value
undo rip metricin
View
Interface view
Parameters
value: Additional metric of RIP routes received on an interface, in the range of 0 to 16.
Description
Use the rip metricin command to configure an additional metric for RIP routes received on an interface.
Use the undo rip metricin command to restore the default.
By default, the additional metric of RIP routes received on an interface is 0.
Before a valid RIP route received on an interface is added to the routing table, the additional metric will
be added to the route. Therefore, if you increase the additional metric, the metric of RIP routes received
on the interface will increase accordingly. If the sum of the additional metric and the original metric is
greater than 16, the metric of the route will be 16.
Related commands: rip metricout.
Examples
# Set the additional metric of RIP routes received on the interface VLAN-interface 10 to 2.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] rip metricin 2
rip metricout
Syntax
rip metricout value
undo rip metricout
View
Interface view
Parameters
value: Additional metric of RIP routes sent out of an interface, in the range of 1 to 16.
Description
Use the rip metricout command to configure an additional metric for RIP routes sent out of an
interface.
Use the undo rip metricout command to restore the default.
To Next Page
Loading...
Need help?
General