1-22
1) Use the snmp-agent trap enable or enable snmp trap updown command to specify the types of
the SNMP traps a device can send (by default, a device can send all types of SNMP traps).
2) Use the snmp-agent target-host command to set the address of the destination for the SNMP
traps.
Related commands: snmp-agent trap enable, snmp-agent trap source, and snmp-agent trap life.
Examples
# Enable sending SNMP traps to 10.1.1.1, and set the community name to public.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] snmp-agent trap enable standard
[Sysname] snmp-agent target-host trap address udp-domain 10.1.1.1 params securityname public
snmp-agent trap enable
Syntax
snmp-agent trap enable [ configuration | flash | ospf [ process-id ] [ ospf-trap-list ] | standard
[ authentication | coldstart | linkdown | linkup | warmstart ]* | system | vrrp [ authfailure |
newmaster ] ]
undo snmp-agent trap enable [ established ]* | configuration | flash | ospf [ process-id ]
[ ospf-trap-list ] | standard [ authentication | coldstart | linkdown | linkup | warmstart ]* | system |
vrrp [ authfailure | newmaster ] ]
View
System view
Parameters
configuration: Specifies to send configuration traps.
flash: Specifies to send Flash traps.
ospf [ process-id ] [ ospf-trap-list ]: Specifies to send OSPF traps. The process-id argument is a process
ID. The ospf-trap-list argument indicates a list of traps to be sent.
standard: Specifies to send SNMP standard notification or traps.
authentication: Specifies to send SNMP authentication failure traps in cases of authentication failures.
coldstart: Specifies to send SNMP cold start traps when the device is rebooted.
linkdown: Specifies to send SNMP linkDown traps when a port becomes down.
linkup: Specifies to send SNMP linkUp traps when a port becomes up.
warmstart: Specifies to send SNMP warm start traps when SNMP is newly launched.
system: Specifies to send H3C-SYS-MAN-MIB (proprietary MIB) traps.
vrrp [ authfailure | newmaster ]: Specifies to send VRRP traps.
Description
Use the snmp-agent trap enable command to enable a device to send SNMP traps that are of
specified types.
To Next Page
Loading...
Need help?
General