1-35
parameters here are used to display all the buffered stop-accounting requests generated from start-time
to stop-time.
user-name user-name: Displays the buffered stop-accounting requests of a specified user. Here,
user-name is a string of up to 184 characters.
Description
Use the display stop-accounting-buffer command to display the non-response stop-accounting
requests buffered in the device.
z You can choose to display the buffered stop-accounting requests of a specified RADIUS scheme,
session (by session ID), or user (by username). You can also specify a time range to display those
generated within the specified time range. The displayed information helps you diagnose and
resolve RADIUS problems.
z If the switch gets no response in a specified time period after sending a stop-accounting request to
a RADIUS server, it will buffer the request and transmit the buffered one until the maximum number
of transmission attempts (set by the retry stop-accounting command) is reached.
Related commands: reset stop-accounting-buffer, stop-accounting-buffer enable, retry
stop-accounting.
Examples
# Display the buffered stop-accounting requests generated from 0:0:0 08/31/2002 to 23:59:59
08/31/2002.
<Sysname> display stop-accounting-buffer time-range 00:00:00-08/31/2002
23:59:59-08/31/2002
Total find 0 record
key
Syntax
key { accounting | authentication } string
undo key { accounting | authentication }
View
RADIUS scheme view
Parameters
accounting: Sets a shared key for RADIUS accounting messages.
authentication: Sets a shared key for RADIUS authentication/authorization messages.
string: Shared key to be set, a string of up to 16 characters.
To Next Page
Loading...
Need help?
General