1-10
Description
Use the display qos-interface traffic-remark-vlanid command to display the VLAN mapping
configuration of a port or a unit.
Related commands: traffic-remark-vlanid.
Examples
# Display the VLAN mapping configuration of Ethernet 1/0/1.
<Sysname> display qos-interface Ethernet1/0/1 traffic-remark-vlanid
Ethernet1/0/1: traffic-remark-vlanid
Inbound:
Matches: Acl 4000 rule 0 running
Remark vlan: 101
Refer to Table 1-3 for the description on the output fields.
display qos-interface traffic-statistic
Syntax
display qos-interface { interface-type interface-number | unit-id } traffic-statistic
View
Any view
Parameters
interface-type interface-number: Specifies the type and number of a port for which traffic accounting
configuration is to be displayed.
unit-id: Unit ID of the switch for which traffic accounting configuration and traffic statistics are to be
displayed. For the value range for the unit-id argument, refer to
Table 1-2.
Description
Use the display qos-interface traffic-statistic command to display the traffic accounting configuration
and traffic statistics of a port or a unit.
Related commands: traffic-statistic.
Examples
# Display the traffic accounting configuration and traffic statistics of Ethernet 1/0/1.
<Sysname> display qos-interface Ethernet1/0/1 traffic-statistic
Ethernet1/0/1: traffic-statistic
Inbound:
Matches: Acl 2000 rule 2 running
6 packets inprofile
0 packet outprofile
Refer to Table 1-3 for the description on the output fields.
To Next Page
Loading...
Need help?
General