5-2
display igmp-snooping group
Syntax
display igmp-snooping group [ vlan vlan-id ]
View
Any view
Parameters
vlan vlan-id: Specifies the VLAN in which the multicast group information is to be displayed, where
vlan-id ranges from 1 to 4094.. If you do not specify a VLAN, this command displays the multicast group
information of all VLANs.
Description
Use the display igmp-snooping group command to display the IGMP Snooping multicast group
information.
Related commands: igmp-snooping, igmp host-join, multicast static-group vlan, multicast
static-group interface, multicast static-group vlan, multicast static-router-port, multicast
static-router-port vlan
Examples
# Display the information about the multicast groups in VLAN 100.
<Sysname> display igmp-snooping group vlan 100
Total 1 IP Group(s).
Total 1 MAC Group(s).
Vlan(id):100.
Total 1 IP Group(s).
Total 1 MAC Group(s).
Static Router port(s):
Ethernet1/0/11
Dynamic Router port(s):
Ethernet1/0/22
IP group(s):the following ip group(s) match to one mac group.
IP group address:228.0.0.1
Static host port(s):
Ethernet1/0/23
Dynamic host port(s):
Ethernet1/0/10
MAC group(s):
MAC group address:0100-5e00-0001
Host port(s):Ethernet1/0/10 Ethernet1/0/23
To Next Page
Loading...
Need help?
General