1-13
for the FTP client, the configured source IP address will be displayed. If neither a source IP address nor
source interface is specified for the FTP client, 0.0.0.0 will be displayed.
If no source IP address is specified for the FTP client, the switch searches the entry with the destination
as the subnet where the FTP server resides, and uses the IP address of the outbound interface in the
entry as the source IP address.
Examples
# Display the source IP address that the FTP client uses every time it connects to an FTP server.
<Sysname> display ftp source-ip
The source IP you specified is 192.168.0.1
ftp
Syntax
ftp [ cluster | remote-server [ port-number ] ]
View
User view
Parameters
cluster: Connects to the configured FTP server of a cluster. For the configuration of the FTP server of a
cluster, refer to the Cluster part of this manual.
remote-server: Host name or IP address of an FTP server, a string of 1 to 20 characters.
port-number: Port number of the FTP server, in the range 0 to 65535. The default is 21.
Description
Use the ftp command to establish a control connection with an FTP server. If you enter a correct
username and password, you can enter FTP client view.
Examples
# Connect to the FTP server whose IP address is 2.2.2.2.
<Sysname> ftp 2.2.2.2
Trying ...
Press CTRL+K to abort
Connected.
220 FTP service ready.
User(none):admin
331 Password required for admin.
Password:
230 User logged in.
[ftp]
ftp { cluster | remote-server } source-interface
Syntax
ftp { cluster | remote-server } source-interface interface-type interface-number
To Next Page
Loading...
Need help?
General