1-3
Table 1-2 display poe interface command output description
Field Description
PORT INDEX Port index
POWER Power status on the port: ON/OFF
ENABLE PoE enabled/disabled status on the port
MODE
PoE mode on the port:
z signal: PoE through the signal cable
z spare: PoE through the spare cable
PRIORITY
PoE priority of the port:
z critical: Highest
z high: High
z low: Low
STATUS
PoE status on the port:
z user command set port to off: PoE to the port is turned off by the
user
z Standard PD was detected: A standard PD is detected
z PD detection is in process: PDs are being detected
z If the poe enable command is configured on a port, and the port is
not connected to a standard PD (for example, a PC),
“ non-standard PD connected” will be displayed.
display poe interface power
Syntax
display poe interface power [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Port type and port number.
Description
Use the display poe interface power command to view the power information of a specific port of the
switch. If the interface-type interface-number argument is not specified, the command displays the
power information of all ports of the switch.
Examples
# Display the power information of Ethernet 1/0/10.
<Sysname> display poe interface power Ethernet1/0/10
Port power :12400 mW
# Display the power information of all ports.
<Sysname> display poe interface power
PORT INDEX POWER (mW) PORT INDEX POWER (mW)
Ethernet1/0/1 0 Ethernet1/0/2 0
To Next Page
Loading...
Need help?
General