H3C S3600 Series Command Manual

6-1
6 Route Capacity Configuration Commands
z The term router in this chapter refers to a router in a generic sense or an Ethernet switch running a
routing protocol.
z The S3600-SI series do not support route capacity configuration.
Route Capacity Configuration Commands
display memory
Syntax
display memory [ unit unit-id ]
Mode
Any view
Parameters
unit-id: Unit ID.
Description
Use the display memory command to display the memory usage.
Examples
# Display the current memory usage of the switch.
<Sysname> display memory
Unit 1
System Available Memory(bytes): 33631488
System Used Memory(bytes): 16122304
Used Rate: 47%
The following table describes the fields of the command:
Table 6-1 Description on the fields of the display memory command
Field Description
Unit Specifies a Unit ID
System Available Memory(bytes) Free memory size, in bytes, of the switch
System Used Memory(bytes) Occupied memory size, in bytes, of the switch

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English