5-9
node: Specifies a node index in a routing policy.
node-number: Index of the node in a routing policy, in the range 0 to 2047. When this routing policy is
used, the node with smaller node-number will be matched first.
Description
Use the route-policy command to create a routing policy or enter the Route-policy view.
Use the undo route-policy command to delete the created Route-policy.
By default, no Route-policy is defined.
Route-policy is used for route information filter. A Route-policy comprises some nodes and each node
comprises some if-match clauses and apply clauses.
An if-match clause defines the match rules of this node. An apply clause defines the actions after
filtering through this node. The filtering relationship between the if-match clauses of the node is AND.
That is, all if-match clauses of the node must be met.
The filtering relation between Route-policy nodes is OR. That is, filtering through one node means
filtering through this Route-policy. If the information does not filter through any node, it cannot filter
through this Route-policy.
Related commands: if-match interface, if-match acl, if-match ip-prefix, if-match ip next-hop,
if-match cost, if-match tag, apply cost, apply tag.
Examples
# Configure Route-policy policy1, with the node number of 10 and the match mode of permit, and enter
Route policy view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] route-policy policy1 permit node 10
%New sequence of this list
[Sysname-route-policy]
To Next Page
Loading...
Need help?
General