3-16
System View: return to User View with Ctrl+Z.
[Sysname] patch load S3600_1510_P001.pat
patch run
Syntax
patch run
View
System view
Parameters
None
Description
Use the patch run command to place ACTIVE patches to the RUNNING state.
This command is applicable to ACTIVE patches only. After a system reboot, running patches remain in
the RUNNING state and keep working.
Examples
# Load patch file S3600_1510_P001.pat.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] patch load S3600_1510_P001.pat
# Activate the loaded patch.
[Sysname] patch activate
# Place ACTIVE patches into the RUNNING state.
[Sysname] patch run
reboot
Syntax
reboot [ unit unit-id ]
View
User view
Parameters
unit-id: Unit ID of a switch.
Description
Use the reboot command to restart a specified Ethernet switch.
To Next Page
Loading...
Need help?
General