1-31
logging-host
Syntax
logging-host ip-address
undo logging-host
View
Cluster view
Parameters
ip-address: IP address of the device to be configured as the log host of a cluster.
Description
Use the logging-host command to configure a shared log host for a cluster on the management
device.
Use the undo logging-host command to remove the shared log host setting.
By default, no shared log host is configured.
After setting the IP address of a log host for the cluster, the member devices in the cluster can send logs
to the log host through the management device.
Note that you must execute the command on a management device.
For how to configure a switch to send logs to the log host, refer to Information Center Operation.
Examples
# Configure the device with IP address 10.10.10.9 as the log host of a cluster.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] logging-host 10.10.10.9
management-vlan
Syntax
management-vlan vlan-id
undo management-vlan
View
System view
Parameters
vlan-id: ID of the VLAN to be specified as the management VLAN.
Description
Use the management-vlan command to specify the management VLAN on the switch.
Use the undo management-vlan command to restore the default management VLAN.
By default, VLAN 1 is used as the management VLAN.
To Next Page
Loading...
Need help?
General