1-1
1 IP Routing Table Commands
z The term router in this chapter refers to a router in a generic sense or an Ethernet switch running a
routing protocol.
z The S3600-SI series do not support OSPF.
z The feature of specifying the ABR of an NSSA area as the Type-7 LSAs translator is added. For the
command used, refer to
nssa.
z The feature of configuring an OSPF interface to unicast packets on a P2MP network is added. For
the command used, refer to
ospf network-type.
IP Routing Table Commands
display ip routing-table
Syntax
display ip routing-table [ | { begin | exclude | include } regular-expression ]
View
Any view
Parameters
regular-expression: Regular expression, a string of 1 to 256 case-sensitive characters used for
specifying routing entries.
|: Uses the regular expression to match the output routing information.
begin: Displays the routing information from the route entry containing the specified character string.
include: Displays all routing information containing the specified character string.
exclude: Displays all routing information without the specified character string.
For details about regular expressions, refer to Configuration File Management Operation of this
manual.
To Next Page
Loading...
Need help?
General