1-8
mirroring-group remote-probe vlan
Syntax
mirroring-group group-id remote-probe vlan remote-probe-vlan-id
undo mirroring-group group-id remote-probe vlan remote-probe-vlan-id
View
System view
Parameters
group-id: Number of a port mirroring group, in the range 1 to 20.
remote-probe vlan remote-probe-vlan-id: Specifies the remote-probe VLAN for the mirroring group.
Description
Use the mirroring-group remote-probe vlan command to specify the remote-probe VLAN for a
remote source/destination mirroring group.
Use the undo mirroring-group remote-probe vlan command to remove the configuration of
remote-probe VLAN for a remote source/destination mirroring group.
Note that, before configuring a VLAN as the remote-probe VLAN for a remote source/destination
mirroring group, you need to use the remote-probe vlan enable command to configure the VLAN as a
remote-probe VLAN first.
Related commands: display mirroring-group, remote-probe vlan enable.
This command is only available for S3600-EI series Ethernet switches.
Examples
# Configure VLAN 100 as the remote-probe VLAN of remote source mirroring group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] vlan 100
[Sysname-vlan100] remote-probe vlan enable
[Sysname-vlan100] quit
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 remote-probe vlan 100
mirroring-port
Syntax
mirroring-port { both | inbound | outbound }
undo mirroring-port
To Next Page
Loading...
Need help?
General