1-41
Parameters
None
Description
Use the radius client enable command to enable RADIUS authentication and accounting ports.
Use the undo radius client command to disable RADIUS authentication and accounting ports.
By default, RADIUS authentication and accounting ports are enabled.
If you want to use the switch as a RADIUS client, you need to ensure that the ports for RADIUS
authentication and accounting are open. Otherwise, you can disable the ports to improve security of the
switch.
Related commands: radius scheme.
Examples
# Disable the RADIUS authentication and accounting ports.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] undo radius client enable
radius nas-ip
Syntax
radius nas-ip ip-address
undo radius nas-ip
View
System view
Parameters
ip-address: Source IP address to be set, an IP address of this device. This address can neither be the
all 0's address nor be a Class-D address.
Description
Use the radius nas-ip command to set the source IP address of outgoing RADIUS messages.
Use the undo radius nas-ip command to restore the default setting.
By default, no source IP address is set, and the IP address of corresponding outbound interface is used
as the source IP address of RADIUS messages.
The nas-ip command in RADIUS scheme view has the same function as the radius nas-ip command
in system view; and the configuration in RADIUS scheme view takes precedence over that in system
view.
To Next Page
Loading...
Need help?
General