4-46
After you use this command to reset an OSPF process:
z Invalid LSA is cleared immediately before LSA times out.
z A new Router ID takes effect if the Router ID changes.
z DR and BDR are re-elected conveniently.
z OSPF configuration before the restart will not lose.
After this command is issued, the system will prompt you to confirm whether to re-enable OSPF.
Examples
# Reset all the OSPF processes.
<Sysname> reset ospf all
# Reset OSPF process 200.
<Sysname> reset ospf 200
reset ospf statistics
Syntax
reset ospf statistics { all | process-id }
View
User view
Parameters
all: Clears the statistics of all OSPF processes.
process-id: OSPF process ID, in the range of 1 to 65535.
Description
Use the reset ospf statistics command to clear the statistic of OSPF process(es).
Examples
# Clear the statistics of all OSPF processes.
<Sysname> reset ospf statistics all
router id
Syntax
router id router-id
undo router id
View
System view
Parameters
router-id: Router ID, in dotted decimal notation.
Description
Use the router id command to configure the ID of a router running the OSPF protocol.
To Next Page
Loading...
Need help?
General