1-1
1 Link Aggregation Configuration Commands
Link Aggregation Configuration Commands
display link-aggregation interface
Syntax
display link-aggregation interface interface-type interface-number [ to interface-type
interface-number ]
View
Any view
Parameters
interface-type: Port type.
interface-number: Port number.
to: Specifies a port index range, with the two interface-type interface-number argument pairs around it
as the two ends.
Description
Use the display link-aggregation interface command to display the link aggregation details about a
specified port or port range.
Note that as ports in a manual link aggregation groups do not acquire the information about their peers
automatically, so the entries in the information about the peer ports displayed are all 0 instead of the
actual values.
Examples
# Display the link aggregation details on Ethernet 1/0/1.
<Sysname> display link-aggregation interface Ethernet1/0/1
Ethernet1/0/1:
Selected AggID: 1
Local:
Port-Priority: 32768, Oper key: 2, Flag: 0x45
Remote:
System ID: 0x8000, 0000-0000-0000
Port Number: 0, Port-Priority: 32768 , Oper-key: 0, Flag: 0x38
Received LACP Packets: 0 packet(s), Illegal: 0 packet(s)
Sent LACP Packets: 0 packet(s)
To Next Page
Loading...
Need help?
General