1-9
#
interface Ethernet1/0/23
#
interface Ethernet1/0/24
#
interface GigabitEthernet1/1/1
#
interface GigabitEthernet1/1/2
#
interface GigabitEthernet1/1/3
#
interface GigabitEthernet1/1/4
#TOPOLOGYCFG. MUST NOT DELETE
#
undo irf-fabric authentication-mode
#GLBCFG. MUST NOT DELETE
#
interface NULL0
#
user-interface aux 0 4
idle-timeout 0 0
user-interface aux 5 7
user-interface vty 0 4
authentication-mode none
user privilege level 3
set authentication password simple 1
#
return
The configuration information output above in turn is the system configuration, logical interface
configuration, physical port configuration, and user interface configuration.
display startup
Syntax
display startup [ unit unit-id ]
View
Any view
Parameters
unit unit-id: Specifies the unit ID of a switch. With this keyword-argument combination specified, this
command can display the startup configuration file information of the specified unit.
Description
Use the display startup command to display the startup configuration of a switch.
Note that:
To Next Page
Loading...
Need help?
General