H3C S3600 Series Command Manual

1-6
Field Description
(10.0.0.4, 225.1.1.1) Multicast source and group addresses of the entry
iif Vlan-interface2, 0 oifs
The incoming interface of the multicast forwarding
table is VLAN-interface 2, and the multicast
forwarding table does not have an outgoing
interface.
Matched 122 pkts(183000 bytes), Wrong If 0
pkts
Forwarded 122 pkts(183000 bytes)
122 packets of totally 183,000 bytes match the (S,
G) entry, and 0 error packets match the (S, G) entry.
122 packets of totally 183,000 bytes have been
forwarded.
display multicast routing-table
Syntax
display multicast routing-table [ group-address [ mask { mask | mask-length } ] | source-address
[ mask { mask | mask-length } ] | incoming-interface { interface-type interface-number | register } ]*
View
Any view
Parameters
group-address: Multicast group address, in the range of 224.0.0.0 to 239.255.255.255. With this
argument provided, the command displays the multicast routing entries for the specified multicast
group.
source-address: Multicast source address. With this argument provided, the command displays the
multicast routing entries for the specified multicast source.
mask: Mask of the multicast group address or multicast source address, 255.255.255.255 by default.
mask-length: Mask length of the multicast group address or multicast source address. For a multicast
group address, this argument is in the range of 4 to 32; for a multicast source address, this argument is
in the range of 0 to 32. The system default is 32 in both cases.
incoming-interface: Displays multicast routing entries that contain the specified incoming interface.
interface-type interface-number: Specifies an interface by its type and number.
register: Displays the routing entries in which the incoming interface is the PIM-SM register interface.
Description
Use the display multicast routing-table command to display the multicast routing table information.
The multicast routing table is the basis of multicast data delivery. You can view the multicast routing
table entries to determine whether (S, G) entries have been created with correct outgoing and incoming
interfaces.
Related commands: reset multicast routing-table, display multicast forwarding-table.
Examples
# Display the multicast routing table information.
<Sysname> display multicast routing-table

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English