1-7
ntp-service authentication-keyid
Syntax
ntp-service authentication-keyid key-id authentication-mode md5 value
undo ntp-service authentication-keyid key-id
View
System view
Parameters
key-id: Authentication key ID, in the range of 1 to 4294967295. You can configure up to 1024 keys.
value: Authentication key string. You can input 1 to 16 simple text characters, or 24 cipher text
characters.
Description
Use the ntp-service authentication-keyid command to configure an NTP authentication key.
Use the undo ntp-service authentication-keyid command to remove an NTP authentication key.
By default, no NTP authentication key is configured.
Currently, the system only supports the Message Digest 5 (MD5) algorithm.
After configuring the NTP authentication key, you need to use the ntp-service reliable
authentication-keyid command to specify the authentication key as a trusted key.
Related commands: ntp-service reliable authentication-keyid.
Examples
# Configure an MD5 authentication key, with the key ID being 10 and the key being abc.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] ntp-service authentication enable
[Sysname] ntp-service authentication-keyid 10 authentication-mode md5 abc
ntp-service broadcast-client
Syntax
ntp-service broadcast-client
undo ntp-service broadcast-client
View
VLAN interface view
Parameters
None
Description
Use the ntp-service broadcast-client command to configure an Ethernet switch to operate in the NTP
broadcast client mode and receive NTP broadcast packets through the current interface.
To Next Page
Loading...
Need help?
General