1-3
Table 1-1 Description on the fields of the display interface Vlan-interface command
Field Description
Vlan-interface2 current state
The state of the VLAN interface, which can be
one of the following:
z Administratively DOWN: This VLAN interface
has been manually disabled with the
shutdown command.
z DOWN: The administrative state of this VLAN
interface is up, but its physical state is down.
It indicates that the VLAN corresponding to
this interface does not contain ports in up
state (possibly because the lines have failed).
z UP: The administrative and physical states of
this VLAN interface are both up.
Line protocol current state
The link layer protocol state of the VLAN
interface, which can be one of the following:
z DOWN: The protocol state of this VLAN
interface is down, usually because no IP
address is configured.
z UP: The protocol state of this VLAN interface
is up.
IP Sending Frames' Format is
PKTFMT_ETHNT_2
Format of the frames sent from the VLAN
interface. PKTFMT_ETHNT 2 indicates that this
VLAN interface sends Ethernet II frames. Refer
to the VLAN configuration part in the
accompanied operation manual for information
about frame formats.
Hardware address
MAC address corresponding to the VLAN
interface
Internet Address IP address corresponding to the VLAN interface
10.1.1.1/24 Primary Primary IP address of this VLAN interface
1.1.2.1/24 Sub Secondary IP address of this VLAN interface
Description Description string of the VLAN interface
The Maximum Transmit Unit Maximum transmission unit (MTU)
For information about how to configure an IP address for a VLAN interface, refer to the description on
the ip address command in the IP Address and Performance Command part.
display vlan
Syntax
display vlan [ vlan-id1 [ to vlan-id2 ] | all | dynamic | static ]
View
Any view
To Next Page
Loading...
Need help?
General