1-56
undo data-flow-format { data | packet }
View
HWTACACS scheme view
Parameters
data: Sets the data unit of outgoing HWTACACS data flows, which can be byte, giga-byte, kilo-byte, or
mega-byte.
packet: Sets the packet unit of outgoing HWTACACS data flows, which can be one-packet, giga-packet,
kilo-packet, or mega-packet.
Description
Use the data-flow-format command to set the units of data flows to TACACS servers.
Use the undo data-flow-format command to restore the default units.
By default, the data unit and packet unit for outgoing HWTACACS flows are byte and one-packet
respectively.
Note that the specified unit of data flows sent to the TACACS server must be consistent with the traffic
statistics unit of the TACACS server. Otherwise, accounting cannot be performed correctly.
Related commands: display hwtacacs.
Examples
# Specify to measure data and packets in data flows to TACACS servers in kilo-bytes and kilo-packets
respectively in HWTACACS scheme hwt1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs scheme hwt1
[Sysname- hwtacacs-hwt1] data-flow-format data kilo-byte
[Sysname- hwtacacs-hwt1] data-flow-format packet kilo-packet
display hwtacacs
Syntax
display hwtacacs [ hwtacacs-scheme-name [ statistics ] ]
View
Any view
Parameters
hwtacacs-scheme-name: HWTACACS scheme name, a string of 1 to 32 characters. This name is
case-insensitive. If this argument is not specified, the system displays information about all
HWTACACS schemes.
statistics: Displays statistics about one or all HWTACACS schemes.
Description
Use the display hwtacacs command to display configuration or statistics information of one specified
or all HWTACACS schemes.
To Next Page
Loading...
Need help?
General