H3C S3600 Series Command Manual

2-3
Field Description
Value of maximum query response time for
IGMP(in seconds): 10
The maximum response time for IGMP general
queries is 10 seconds (default).
Value of robust count for IGMP: 2 The IGMP robustness variable is 2 (default).
Value of startup query interval for IGMP(in
seconds): 15
The IGMP startup query interval is 15 seconds
(default).
Value of last member query interval for IGMP(in
seconds): 1
The IGMP last member query interval is 1 second
(default).
Value of query timeout for IGMP version 1(in
seconds): 400
The query timeout time for IGMPv1 is 400
seconds (default).
Policy to accept IGMP reports: none
IGMP multicast group filtering policy for
controlling the access to multicast groups.
“None” means no filtering policy is applied;
otherwise, the applied policy is displayed. For
example, “acl 2000, only for IGMP version 1”
means ACL 2000 is applied only on IGMPv1
reports.
Querier for IGMP: 10.1.0.5 (this router)
The IGMP querier address is 10.1.0.5 (this
device).
IGMP group limit: 256
The maximum number of IGMP multicast groups
that can be joined on the VLAN interface is 256.
Total 1 IGMP group reported
Total number of IGMP multicast groups on the
interface is 1.
igmp enable
Syntax
igmp enable
undo igmp enable
View
Interface view
Parameters
None
Description
Use the igmp enable command to enable IGMP on an interface.
Use the undo igmp enable command to disable IGMP on an interface.
By default, IGMP is disabled on an interface. .
These commands do not take effect until the multicast routing feature is enabled. You need to use this
command before you can configure other IGMP features.
Related commands: multicast routing-enable.
Examples
# Enable IGMP on VLAN-interface 10.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English