1-23
Parameters
url-string: URL of the web page used to modify user password on the self-service server. It is a string of
1 to 64 characters. This string cannot contain any question mark "?". If the actual URL of the self-service
server contains a question mark, you should change it to an elect bar "|".
Description
Use the self-service-url enable command to enable the self-service server location function
Use the self-service-url disable command to disable the self-service server location function
Use the undo self-service-url command to restore the default state of this function.
By default, this function is disabled.
Note that:
z This command must be used with the cooperation of a self-service-supported RADIUS server
(such as CAMS). Through self-service, users can manage and control their accounts or card
numbers by themselves. A server installed with the self-service software is called a self-service
server.
z After this command is executed on the switch, a user can locate the self-service server through the
following operation: choose [change user password] on the 802.1x client, the client opens the
default browser (for example, IE or Netscape) and locates the URL page used to change user
password on the self-service server. Then, the user can change the password.
z A user can choose the [change user password] option on the client only after passing the
authentication. If the user fails the authentication, this option is in grey and is unavailable.
Examples
# Under the default ISP domain "system", set the URL of the web page used to modify user password
on the self-service server to http://10.153.89.94/selfservice/modPasswd1x.jsp|userName.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] domain system
[Sysname-isp-system] self-service-url enable
http://10.153.89.94/selfservice/modPasswd1x.jsp|userName
service-type
Syntax
service-type { ftp | lan-access | { telnet | ssh | terminal }* [ level level ] }
undo service-type { ftp | lan-access | { telnet | ssh | terminal }* }
View
Local user view
Parameters
ftp: Specifies that this is an FTP user.
lan-access: Specifies that this is a LAN access user (who is generally an Ethernet access user, for
example, 802.1x user).
telnet: Authorizes the user to access the Telnet service.
To Next Page
Loading...
Need help?
General