1-3
127.0.0.0/8 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
Table 1-1 Description on the fields of the display ip routing-table command
Field Description
Destination/Mask Destination address/mask length
Protocol Routing protocol
Pre Route preference
Cost Route cost
Nexthop Next hop address
Interface
Output interface, through which the data packets destined for
the destination network segment are sent
display ip routing-table acl
Syntax
display ip routing-table acl acl-number [ verbose ]
View
Any view
Parameters
acl-number: Basic access control list number, in the range of 2000 to 2999.
verbose: With this keyword specified, detailed information of routes in the active or inactive state that
match the ACL is displayed. With this keyword not specified, brief information of only the routes in the
active state that match the ACL is displayed.
Description
Use the display ip routing-table acl command to display the information of routes that match the
specified ACL.
Examples
# Display the information of ACL 2100.
<Sysname> display acl 2100
Basic ACL 2100, 1 rule
Acl's step is 1
rule 0 permit source 192.168.1.0 0.0.0.255
For details about the display acl command, refer to ACL Command.
# Display the information of routes that match ACL 2100.
<Sysname> display ip routing-table acl 2100
Routes matched by access-list 2100:
Summary count: 2
Destination/Mask Protocol Pre Cost Nexthop Interface
192.168.1.0/24 DIRECT 0 0 192.168.1.2 Vlan-interface2
To Next Page
Loading...
Need help?
General