H3C S3600 Series

1-57
Related commands: hwtacacs scheme.
Examples
# Display configuration information of HWTACACS scheme ht1.
<Sysname> display hwtacacs ht1
-------------------------------------------------------------------- HWTACACS-server
template name : ht1
Primary-authentication-server : 172.31.1.11:49
Primary-authorization-server : 172.31.1.11:49
Primary-accounting-server : 172.31.1.11:49
Secondary-authentication-server : 0.0.0.0:0
Secondary-authorization-server : 0.0.0.0:0
Secondary-accounting-server : 0.0.0.0:0
Current-authentication-server : 172.31.1.11:49
Current-authorization-server : 172.31.1.11:49
Current-accounting-server : 172.31.1.11:49
Source-IP-address : 0.0.0.0
key authentication : 790131
key authorization : 790131
key accounting : 790131
Quiet-interval(min) : 5
Response-timeout-Interval(sec) : 5
Realtime-accouting-Interval(min): 12
Stop-acct-PKT resending times : 100
Domain-included : No
Traffic-unit : B
Packet traffic-unit : one-packet
display stop-accounting-buffer
Syntax
display stop-accounting-buffer hwtacacs-scheme hwtacacs-scheme-name
View
Any view
Parameters
hwtacacs-scheme hwtacacs-scheme-name: Displays the buffered stop-accounting requests of a
specified HWTACACS scheme. Here, hwtacacs-scheme-name is a string of up to 32 characters.
Description
Use the display stop-accounting-buffer command to display stop-accounting requests buffered in the
switch.
Related commands: reset stop-accounting-buffer, stop-accounting-buffer enable, retry
stop-accounting.