2-5
Examples
# Create a QoS profile named a123.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] qos-profile a123
[Sysname-qos-profile-a123]
qos-profile port-based
Syntax
qos-profile port-based
undo qos-profile port-based
View
Ethernet port view
Parameters
None
Description
Use the qos-profile port-based command to configure the QoS profile application mode on a port to
be port-based.
Use the undo qos-profile port-based command to restore the default.
By default, the application mode of a QoS profile is user-based.
Note that:
z If the 802.1x authentication is MAC-based, you need to configure the QoS profile application mode
to be user-based.
z If the 802.1x authentication is port-based, you need to configure the QoS profile application mode
to be port-based.
Examples
# Configure the QoS profile application mode on Ethernet 1/0/1 to be port-based.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] qos-profile port-based
traffic-limit
Syntax
traffic-limit inbound acl-rule [ union-effect ] [ egress-port interface-type interface-number ]
target-rate [ burst-bucket burst-bucket-size ] [ exceed action ]
undo traffic-limit inbound acl-rule
To Next Page
Loading...
Need help?
General