3-15
By default, the additional metric of RIP routes sent out of an interface is 1.
With the command configured on an interface, the metric of RIP routes sent on the interface will be
increased.
Related commands: rip metricin.
Examples
# Set the additional metric of RIP routes sent out of the interface VLAN-interface 10 to 2.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] rip metricout 2
rip output
Syntax
rip output
undo rip output
View
Interface view
Parameters
None
Description
Use the rip output command to enable an interface to transmit RIP packets.
Use the undo rip output command to disable an interface from transmitting RIP packets.
By default, all interfaces except loopback interfaces are enabled to transmit RIP packets.
Related commands: rip input, rip work.
Examples
# Disable the interface VLAN-interface 10 from transmitting RIP packets.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] undo rip output
rip split-horizon
Syntax
rip split-horizon
undo rip split-horizon
View
Interface view
To Next Page
Loading...
Need help?
General