2-5
A port or a link aggregation group cannot serve as a member port for two smart link groups. On the
other hand, a port or a link aggregation group cannot serve as a member for a smart link group and a
monitor link group at the same time. However, a smart link group can serve as the uplink member port
of a monitor link group.
Examples
# Configure Ethernet 1/0/8 as a downlink port of monitor link group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/8
[Sysname-Ethernet1/0/8] port monitor-link group 1 downlink
smart-link group
Syntax
smart-link group group-id uplink
undo smart-link group group-id
View
Monitor link group view
Parameters
group-id: Smart link group ID, ranging 1 to 24.
uplink: Specifies the specified smart link group as the uplink port of the monitor link group
Description
Use the smart-link group command to configure the specified smart link group as the uplink port of the
monitor link group.
Use the undo smart-link group command to remove the configuration.
A smart link group can belong to only one monitor link group and can be configured only as an uplink
port of the monitor link group.
Examples
# Configure smart link group 1 as the uplink port of monitor link group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] monitor-link group 1
[Sysname-mtlk-group1] smart-link group 1 uplink
To Next Page
Loading...
Need help?
General