1-10
Use the undo port-security authorization ignore command to restore the default configuration.
By default, the port uses (does not ignore) the authorization information delivered by the RADIUS
server.
You can use the display port-security command to check whether the port will use the authorization
information delivered by the RADIUS server.
After a RADIUS user passes authentication, the RADIUS server authorizes the attributes configured for
the user account such as the dynamic VLAN configuration. For more information, refer to AAA
Command.
Examples
# Configure Ethernet 1/0/2 to ignore the authorization information delivered by the RADIUS server.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/2
[Sysname-Ethernet1/0/2] port-security authorization ignore
port-security max-mac-count
Syntax
port-security max-mac-count count-value
undo port-security max-mac-count
View
Ethernet port view
Parameters
count-value: Maximum number of MAC addresses allowed on the port, in the range of 1 to 1024.
Description
Use the port-security max-mac-count command to set the maximum number of MAC addresses
allowed on the port.
Use the undo port-security max-mac-count command to cancel this limit.
By default, there is no limit on the number of MAC addresses allowed on the port.
To Next Page
Loading...
Need help?
General