H3C S3600 Series

3-17
source-lifetime
Syntax
source-lifetime interval
undo source-lifetime
View
PIM view
Parameters
interval: Multicast source lifetime in seconds, with an effective range of 210 to 31536000.
Description
Use the source-lifetime command to configure the multicast source lifetime, also known as (S, G)
aging time.
Use the undo source-lifetime command to restore the default.
By default, the lifetime of a multicast source is 210 seconds.
The configured multicast source lifetime applies to all (S, G) entries in the PIM routing table and the
multicast routing table rather than on a specific (S, G) entry, and the configuration changes the aging
time of all the existing (S, G) entries.
Examples
# Set the multicast source lifetime to 3000 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] pim
[Sysname-pim] source-lifetime 3000
source-policy
Syntax
source-policy acl-number
undo source-policy
View
PIM view
Parameters
acl-number: Basic or advanced ACL, in the range of 2000 to 3999.