5-14
View
System view
Parameters
seconds: Aging time of router ports, in the range of 1 to 1,000, in seconds.
Description
Use the igmp-snooping router-aging-time command to configure the aging time of router ports.
Use the undo igmp-snooping router-aging-time command to restore the default aging time.
By default, the aging time of router ports is 105 seconds.
The aging time of router ports should be about 2.5 times the IGMP query interval.
Related commands: igmp-snooping max-response-time, igmp-snooping.
Examples
# Set the aging time of the router port to 500 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] igmp-snooping router-aging-time 500
igmp-snooping version
Syntax
igmp-snooping version version-number
undo igmp-snooping version
View
VLAN view
Parameters
version-number: IGMP Snooping version, in the range of 2 to 3 and defaulting to 2.
Description
Use the igmp-snooping version command to configure the IGMP Snooping version in the current
VLAN.
Use the undo igmp-snooping version command to restore the default IGMP Snooping version.
This command can take effect only if IGMP Snooping is enabled in the VLAN.
Related commands: igmp-snooping enable.
Examples
# Set IGMP Snooping version to version 3 in VLAN 100.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] igmp-snooping enable
Enable IGMP-Snooping ok.
[Sysname] vlan 100
To Next Page
Loading...
Need help?
General