1-5
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
Table 1-4 Description on the fields of the display ipv6 interface command
Field Description
Vlan-interface1 current
state
VLAN interface link state:
z Administratively DOWN: Indicates the VLAN interface is
administratively down; that is, the interface is shut down using the
shutdown command.
z DOWN: Indicates the VLAN interface is administratively up but its
physical state is down; that is, no ports in the VLAN are up, which
may be caused by a link failure.
z UP: Indicates the administrative and physical states of the VLAN
interface are both up.
Line protocol current state
Link layer protocol state of an interface:
z DOWN: Indicates the link layer protocol state of the VLAN
interface is down, generally because no IP address is configured.
z UP: Indicates the link layer protocol state of the VLAN interface is
up.
IPv6 is enabled
IPv6 forwarding state of an interface (after an IPv6 address is
configured for an interface, IPv6 is automatically enabled on it; IPv6 is
enabled in the example)
link-local address Link-local address configured on an interface
Global unicast address(es) Aggregatable global unicast address configured on an interface
Joined group address(es) Address of the multicast group that an interface joins
MTU Maximum transmission unit of an interface
ND DAD is enabled,
number of DAD attempts
Number of duplicate address detection (DAD) attempts, with DAD
enabled
z If DAD is enabled, the number of neighbor request messages is
also displayed (configured by using the ipv6 nd dad attempts
command)
z If DAD is disabled, “ND DAD is disabled” is displayed. (You can
set the number of neighbor request messages for DAD to 0 to
disable this function.)
ND reachable time
Neighbor reachable time (which can be configured by using the ipv6
nd nud reachable-time command)
ND retransmit interval
Interval for retransmitting a neighbor solicitation (NS) message
(which can be configured by using the ipv6 nd ns retrans-timer
command)
Hosts use stateless
autoconfig for addresses
Hosts use stateless auto-configuration mode to acquire IPv6
addresses
#: View the brief IPv6 information of all interfaces.
<Sysname> display ipv6 interface brief
*down: administratively down
(s): spoofing
Interface Physical Protocol IPv6 Address
Vlan-interface1 up up 2008::5600
To Next Page
Loading...
Need help?
General