1-11
Parameters
None
Description
Use the remote-probe vlan enable command to configure the current VLAN as the remote-probe
VLAN.
Use the undo remote-probe vlan enable command to restore the remote-probe VLAN to a normal
VLAN.
Note that:
z You cannot configure a default VLAN, a management VLAN, or a dynamic VLAN as the
remote-probe VLAN.
z A remote-probe VLAN cannot be removed directly. To do that, you need to run the undo
remote-probe vlan enable command in VLAN view first.
Related commands: mirroring-group remote-probe vlan.
This command is only available for S3600-EI series Ethernet switches.
Examples
# Configure VLAN 5 as the remote-probe VLAN.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] vlan 5
[Sysname-vlan5] remote-probe vlan enable
To Next Page
Loading...
Need help?
General