H3C S3600 Series

1-29
View
System view
Parameters
ip-address: IP address from which a HWPing server performs UDP listening.
port-number: Port from which a HWPing server performs UDP listening. The value ranges from 1 to
65535. In is not recommended to use a port with a number greater than 50000 or some special ports
(that is, those used for fixed functions, such as port 1701). Otherwise, the HWPing test may fail.
Description
Use the hwping-server udpecho command to enable UDP listening on a HWPing server.
Use the undo hwping-server udpecho command to disable UDP listening.
When performing a jitter test or a UDP connection test on a specified port of a HWPing client, you must
enable UDP listening on the server if an S3600 switch serves as a HWPing server; otherwise, the test
may fail.
Related commands: hwping-server enable.
Examples
# Enable UDP listening, using 169.254.10.3 as the IP address and 9000 as the port number.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping-server udpecho 169.254.10.3 9000