H3C S3600 Series Command Manual

1-2
View
Any view
Parameters
unit-id: Unit ID of the device.
Description
Use the display info-center command to display the operation status of information center, the
configuration of information channels, the format of time stamp and the information output in case of
fabric.
Related commands: info-center enable, info-center loghost, info-center logbuffer, info-center
console channel, info-center monitor channel, info-center trapbuffer, info-center snmp channel,
info-center timestamp
Examples
# Display the operation status of information center, the configuration of information channels, the
format of time stamp of the current system and the information output status in the IRF fabric.
<Sysname> display info-center
Information Center: enabled
Log host:
the interface name of the source address : Vlan-interface1
192.168.0.2, channel number : 2, channel name : loghost
language : english, host facility local : 7
Console:
channel number : 0, channel name : console
Monitor:
channel number : 1, channel name : monitor
SNMP Agent:
channel number : 5, channel name : snmpagent
Log buffer:
enabled,max buffer size : 1024, current buffer size : 512,
current messages : 512, channel number : 4, channel name : logbuffer
dropped messages : 0, overwritten messages : 586
Trap buffer:
enabled,max buffer size : 1024, current buffer size : 256,
current messages : 5, channel number : 3, channel name : trapbuffer
dropped messages : 0, overwritten messages : 0
Information timestamp setting:
log - date, trap - date, debug - boot
IRF SWITCH OF Device--Unit>1: LOG = enable; TRAP = enable; DEBUG = enable
Table 1-1 display info-center command output description
Field Description
Information Center
Status of the information center:
enabled/disabled

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English