H3C S3600 Series Command Manual

1-13
log and trap information is enabled, with severity being informational; the output of debugging
information is disabled, with severity being debugging. For example, if you execute the command
info-center source snmp channel 5, the command is actually equal to the command info-center
source snmp channel 5 debug level debugging state off log level informational state on trap
level informational state on.
z After you separately set the output rules for a module, you must use the module-name argument to
modify or remove the rules. The new configuration by using the default keyword is invalid on the
module.
z You can configure to output the log, trap and debugging information to the trap buffer, but the trap
buffer only receives the trap information and discards the log and debugging information.
z You can configure to output the log, trap and debugging information to the log buffer, but the log
buffer only receives the log and debugging information and discards the trap information.
z You can configure to output the log, trap and debugging information to the SNMP module, but the
SNMP module only receives the trap information and discards the log and debugging information.
Table 1-4 Default output rules for different output destinations
LOG TRAP DEBUG
Output
destinati
on
Modules
allowed
Enabled/
disabled
Severity
Enabled/
disabled
Severity
Enabled/
disabled
Severity
Console
default
(all
modules)
Enabled warnings Enabled
debuggin
g
Enabled
debuggin
g
Monitor
terminal
default
(all
modules)
Enabled warnings Enabled
debuggin
g
Enabled
debuggin
g
Log host
default
(all
modules)
Enabled
informatio
nal
Enabled
debuggin
g
Disabled
debuggin
g
Trap
buffer
default
(all
modules)
Disabled
informatio
nal
Enabled warnings Disabled
debuggin
g
Log buffer
default
(all
modules)
Enabled warnings Disabled
debuggin
g
Disabled
debuggin
g
SNMP
module
default
(all
modules)
Disabled
debuggin
g
Enabled warnings Disabled
debuggin
g
Log file
default
(all
modules)
Enabled
debuggin
g
Enabled
debuggin
g
Disabled
debuggin
g
Examples
# Set the output channel for the log information of VLAN module to snmpagent and to output
information with severity being emergencies. Log information of other modules cannot be output to this
channel.
<Sysname> system-view
[Sysname] info-center source default channel snmpagent log state off
[Sysname] info-center source vlan channel snmpagent log level emergencies state on

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English