H3C S3600 Series Command Manual

3-10
Field Remarks
RX power high RX power is high.
RX power low RX power is low.
Laser bias current fault Laser bias current fault
Laser temperature fault Laser temperature fault
Laser output power fault Laser output power fault
TX fault TX fault
PMA/PMD receiver local fault PMA/PMD receiver local fault
PCS receive local fault PCS receive local fault
PHY XS receive local fault PHY XS receive local fault
TX bias high TX bias current is high.
TX bias low TX bias current is low.
TX power high TX power is high.
TX power low TX power is low.
Temp high Temperature is high.
Temp low Temperature is low.
Transceiver info I/O error Transceiver information read and write error
Transceiver info checksum error Transceiver information checksum error
Transceiver type and port configuration
mismatch
Transceiver type does not match port configuration.
Transceiver type not supported by port
hardware
Transceiver type is not supported on the port.
For pluggable transceivers supported by S3600 series Ethernet switches, refer to H3C S3600 Series
Ethernet Switches Installation Manual.
Examples
# Display the alarm information of the transceiver on interface GigabitEthernet 1/1/1.
<Sysname> display transceiver alarm interface gigabitethernet 1/1/1
GigabitEthernet1/1/1 transceiver current alarm information:
TX fault

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English