3-2
View
PIM view
Parameters
interface-type interface-number: Specifies an interface that will be configured as a C-BSR. This
configuration takes effect only after PIM-SM is enabled on the interface.
hash-mask-len: Length of the hash mask used for RP calculation. The effective range is 0 to 32.
priority: C-BSR priority. The effective range is 0 to 255, 0 by default.
Description
Use the c-bsr command to configure the specified interface as a C-BSR.
Use the undo c-bsr command to remove the C-BSR configuration.
By default, no C-BSR is configured.
For the configuration of the candidate BSR, the larger bandwidth should be guaranteed because a large
amount of information will be exchanged between the BSR and other devices in the PIM domain.
Related commands: pim sm.
Examples
# Configure VLAN-interface 10 on the switch as a C-BSR with a priority of 2 and the hash mask length
of 24.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] multicast routing-enable
[Sysname] pim
[Sysname-pim] c-bsr vlan-interface 10 24 2
c-rp
Syntax
c-rp interface-type interface-number [ group-policy acl-number | priority priority-value ]*
undo c-rp { interface-type interface-number | all }
View
PIM view
Parameters
interface-type interface-number: Specifies an interface of which the IP address will be advertised as a
C-RP address.
group-policy: Defines a group range to be served by the specified interface after it becomes the RP.
acl-number: Basic ACL number, in the range of 2,000 to 2,999. Used together with the group-policy
keyword, this argument defines the group range mentioned above.
priority priority-value: C-RP priority, in the range of 0 to 255, 0 by default. A greater value means a
lower priority.
all: Removes all C-RPs configured.
To Next Page
Loading...
Need help?
General