1-29
Examples
# Configure that commands at level 1 are available to the users logging in to VTY 0.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface vty 0
[Sysname-ui-vty0] user privilege level 1
# You can verify the above configuration by Telnetting to VTY 0 and displaying the available commands,
as listed in the following.
<Sysname> ?
User view commands:
cluster Run cluster command
debugging Enable system debugging functions
display Display current system information
msdp-tracert MSDP trace route to source RP
mtracert Trace route to multicast source
nslookup Query Internet name servers
ping Ping function
quit Exit from current command view
reset Reset operation
send Send information to other user terminal interfaces
super Set the current user priority level
telnet Establish one TELNET connection
terminal Set the terminal line characteristics
tracert Trace route function
undo Cancel current setting
To Next Page
Loading...
Need help?
General