Rohde & Schwarz SMW200A - Page 1036

Remote Control Commands
R&S
®
SMW200A
1021User Manual 1175.6632.02 ─ 16
Example: See Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1019
Manual operation: See "Acquisition" on page 595
[:SOURce]:BB:MEASurement:POWer:GSOurce <GateSource>
Determines the marker signal defining the signal part to be evaluated. The available
values depend on the selected acquisition ([:SOURce]:BB:MEASurement:POWer:
ACQuisition).
Parameters:
<GateSource> NONE | MARK1 | MARK2 | MARK3 | MGATed
NONE
Default value for nominal and continuous acquisition.
MARK1|MARK2|MARK3
Marker signal as defined in the baseband
MGATed
Reserved for multi gated acquisition
*RST: NONE
Example: See Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1019
Manual operation: See "Gate Source" on page 595
[:SOURce]:BB:MEASurement:POWer:RMODe <RunMode>
Determines whether a single or a continuous measurement is executed.
Parameters:
<RunMode> SINGle | AUTO
*RST: AUTO
Example: See Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1019
Manual operation: See "Run Mode" on page 596
[:SOURce]:BB:MEASurement:POWer:ADD
Adds a measurement.
Example:
See Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1019
Usage: Event
Manual operation: See "Add, Change, Remove, Start, Abort" on page 597
SOURce Subsystem