Monitoring Signal Characteristics
R&S
®
SMW200A
595User Manual 1175.6632.02 ─ 16
Settings:
BB Powers Summary List........................................................................................... 595
Source/Output.............................................................................................................595
Acquisition...................................................................................................................595
Gate Source................................................................................................................595
Sweep Time/Duration..................................................................................................596
Level/PEP................................................................................................................... 596
Run Mode....................................................................................................................596
Add, Change, Remove, Start, Abort............................................................................597
Running/Stopped........................................................................................................ 597
BB Powers Summary List
Displays the measurement results of all currently enabled measurements.
You can configure and enable up to 8 measurements simultaneously. To enable a new
measurement or to change the settings of an existing one, use the Add, Change,
Remove, Start, Abort functions.
"Progress %"
Indicates the status of an initiated measurement.
Remote command:
[:SOURce]:BB:MEASurement:POWer:PROGress? on page 1023
Source/Output
Determines the start and end point for the power measurement, i.e. determines the
influence of which source signal is measured at which output point. Available are mea-
surements at all input and output interfaces of each block belonging to the baseband
domain.
The available acquisition points depend on the current "System Configuration > Fad-
ing/Baseband Configuration".
Remote command:
[:SOURce]:BB:MEASurement:POWer:SOURce on page 1020
[:SOURce]:BB:MEASurement:POWer:OUTPut on page 1020
Acquisition
Determines the used acquisition method, see Chapter 8.2.2.3, "Selecting a Suitable
Acquisition Method", on page 591.
Refer to Chapter 8.2.4, "How to Query Information on the Baseband Power Levels",
on page 597 for examples on using the provided acquisition methods and their appli-
cation fields.
Remote command:
[:SOURce]:BB:MEASurement:POWer:ACQuisition on page 1020
Gate Source
In gated and multi-gated measurements, sets/displays the signal used to determine the
signal part to be measured.
With "Acquisition > Gated", the starting point of the signal measurement is determined
by one of the marker signals "Marker 1/2/3", as enabled for the current baseband sig-
nal source.
Querying Information on the Baseband Power Levels
To Next Page
Loading...
