Rohde & Schwarz SMW200A - Page 1072

Remote Control Commands
R&S
®
SMW200A
1057User Manual 1175.6632.02 ─ 16
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce:IQ:OUTPut:DIGital:BBMM2:STATe ON
Activates the BBMM 2 output connector.
Manual operation: See "State" on page 181
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:PON <Pon>
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:PON <Pon>
Sets the power-on state of the selected digital I/Q output.
Parameters:
<Pon> OFF | UNCHanged
*RST: OFF
Example:
:SOURce:IQ:OUTPut:DIGital:BBMM2:PON OFF
Deactivates the BBMM 2 output connector when the instrument
is switched on.
Manual operation: See "Power-On State" on page 184
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:SRATe:SOURce <Source>
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:SRATe:SOURce <Source>
Selects whether the sample rate is estimated based on the digital signal or is a user-
defined value.
Parameters:
<Source> USER | DOUT
DOUT
Enabled for BBMM1|BBMM2 connectors
*RST: USER
Example:
:SOURce:IQ:OUTPut:DIGital:BBMM2:SRATe:SOURce
DOUT
Sample rate estimation based on the applied I/Q data clock
:SOURce:IQ:OUTPut:DIGital:BBMM2:SRATe?
Manual operation: See "Sample Rate Source" on page 181
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:SRATe <SRate>
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:SRATe <SRate>
Sets/queries the sample rate of the digital I/Q output signal.
SOURce Subsystem