Configuring the Signal in the RF Domain
R&S
®
SMW200A
547User Manual 1175.6632.02 ─ 16
The remote commands required to define these settings are described in Chap-
ter 13.16, "SENSe, READ, INITiate and SLISt Subsystems", on page 812, includ-
ing the triggering of the measurement and the retrieval of measurement results.
Sensor type and serial number
Indicates the type and the serial number of the selected R&S NRP power sensor, and
the channel the sensor is assigned to.
The displayed Level (Peak) / Level (Average) values correspond to the particular sen-
sor.
Remote command:
:SENSe<ch>[:POWer]:TYPE? on page 824
:SENSe<ch>[:POWer]:SNUMber? on page 823
Level (Peak) / Level (Average)
Indicates the measured peak or average level value.
You can also change the unit for the results display: Watt, dBm or dBμV.
Note: Peak level measurements are provided if the power sensor supports this feature.
Remote command:
:READ<ch>[:POWer]? on page 817
:SENSe<ch>:UNIT[:POWer] on page 817
Sensor Mapping
Accesses the NRP Sensor Mapping dialog.
Sensor Settings
One tab per sensor provides the corresponding setting parameters.
State ← Sensor Settings
Activates level measurement.
Remote command:
:INITiate<hw>[:POWer]:CONTinuous on page 816
To query the availability of a sensor at a given connector, use the command :
SENSe<ch>[:POWer]:STATus[:DEVice]? on page 824.
Zero ← Sensor Settings
Activates the auto zero function.
For details, see "About zeroing" on page 544.
Remote command:
:SENSe<ch>[:POWer]:ZERO on page 825
Display ← Sensor Settings
Sets the display mode for power readings.
Permanent ← Display ← Sensor Settings
Activates the permanent indication of the power measurement result in the block dia-
gram.
Improving Level Performance
To Next Page
Loading...
