EasyManua.ls Logo

TP-Link T2600G Series - Configuring Option 82 for Ports

TP-Link T2600G Series
1136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring DHCP Service DHCP L2 Relay Configuration
User Guide
567
The following example shows how to enable DHCP L2 Relay globally and for VLAN 2:
Switch#configure
Switch(config)#ip dhcp l2relay
Switch(config)#ip dhcp l2relay vlan 2
Switch(config)#show ip dhcp l2relay
Global Status: Enable
VLAN ID: 2
Switch(config)#end
Switch#copy running-config startup-config
4.2.2 Configuring Option 82 for Ports
Follow these steps to configure Option 82:
Step 1 configure
Enter Global Configuration Mode.
Step 2 interface {
fastEthernet
port
| range fastEthernet
port-list
| gigabitEthernet
port
| range
gigabitEthernet
port-list
| ten-gigabitEthernet
port
| range ten-gigabitEthernet
port-list
}
Enter Interface Configuration Mode.
Step 3 ip dhcp l2relay information option
Enable the Option 82 feature on the port.
Step 4 ip dhcp l2relay information strategy { keep | replace | drop }
Specify the operation for the switch to take when receiving DHCP packets that include the
Option 82 field.
keep: The switch keeps the Option 82 field of the packets.
replace: The switch replaces the Option 82 field of the packets with a new one. The switch
presets a default circuit ID and remote ID in TLV (Type, Length, and Value) format. You can
also configure the format to include Value only and customize the Value.
drop: The switch discards the packets that include the Option 82 field.
Step 5 ip dhcp l2relay information format { normal | private }
Specify the packet format for the sub-option fields of Option 82.
normal: Indicates the fields consist of three parts: Type, Length, and Value (TLV).
private: Indicates the fields consist of the value only.

Table of Contents

Related product manuals