TP-Link T2600G Series User Manual

User Guide 526
Configuring Routing IPv6 Static Routing Configuration
3.2 Using the CLI
Follow these steps to enable IPv6 routing function and create an IPv6 static route.
Step 1 configure
Enter global configuration mode.
Step 2 ipv6 routing
Enable the IPv6 routing function on the specified Layer 3 interface.
Step 3 ipv6 route {
ipv6-dest-address } { next-hop-address } [ distance ]
Add an IPv6 static route.
ipv6-dest-address: Specify the destination IPv6 address of the packets, in the format of
X:X:X:X::X/<0-128>.
next-hop-address: Specify the IPv6 gateway address to which the packet should be sent
next.
distance: Specify the administrative distance, which is a rating of the trustworthiness of the
routing information. A higher value means a lower trust rating. When more than one routing
protocols have routes to the same destination, only the route that has the shortest distance
will be recorded in the IP routing table. The valid values are from 1 to 255 and the default
value is 1.
Step 4 show ipv6 route [ static | connected ]
Verify the IPv6 route entries of the specified type.
Step 5 end
Return to privileged EXEC mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to create an IPv6 static route with the destination IP
address as 3200::/64 and the next-hop address as 3100::1234:
Switch#configure
Switch(config)#ipv6 route 3200::/64 3100::1234
Switch(config)#show ipv6 route static
Codes: C - connected, S - static
* - candidate default
C 3000::/64 is directly connected, Vlan1
S 3200::/64 [1/0] via 3100::1234, Vlan2
Switch(config)#end
Switch#copy running-config startup-config

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing