TP-Link T2600G Series User Manual

User Guide 622
Configuring QoS Class of Service Configuration
2
Class of Service Configuration
With class of service configurations, you can:
■ Configure port priority
■ Configure 802.1p priority
■ Configure DSCP priority
■ Specify the scheduler settings
Configuration Guidelines
■ Select the priority mode that the ports trust according to your network requirements.
A port can use only one priority to classify the ingress packets. Three priority modes
are supported on the switch: Port Priority, 802.1P Priority and DSCP Priority.
■ Port Priority
In this mode, the switch prioritizes packets according to their ingress ports, regardless
of the packet field or type.
■ 802.1P Priority
802.1P defines the first three bits in 802.1Q Tag as PRI field. The PRI values are from 0
to 7. 802.1P priority determines the priority of packets based on the PRI value.
In this mode, the switch only prioritizes packets with VLAN tag, regardless of the IP
header of the packets.
■ DSCP Priority
DSCP priority determines the priority of packets based on the ToS (Type of Service)
field in their IP header. RFC2474 re-defines the ToS field in the IP packet header as DS
field. The first six bits (bit 0-bit 5) of the DS field is used to represent DSCP priority. The
DSCP values are from 0 to 63.
In this mode, the switch only prioritizes IP packets.
■ Specify the 802.1p to queue mapping according to your needs.
For 802.1p Priority, the packets will be forwarded according to the 802.1p to queue
mapping directly.
For Port Priority and DSCP Priority, the port priority and DSCP priority will first be
mapped to the 8021p priority, and then mapped to the queue according to the 802.1p
to queue mapping.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing