EasyManua.ls Logo

TP-Link T2600G Series - Configuring DSCP Priority

TP-Link T2600G Series
1136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring QoS Class of Service Configuration
User Guide
639
The following example shows how to configure the trust mode of port 1/0/1 as dot1p, map
802.1p priority 3 to TC4, and configure to map the original 802.1p 1 to 802.1p priority 3:
Switch#configure
Switch(config-if)#interface gigabitEthernet 1/0/1
Switch(config-if)#qos trust mode dot1p
Switch(config-if)#exit
Switch(config)#qos cos-map 3 4
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#qos dot1p-remap 1 3
Switch(config-if)#show qos trust interface gigabitEthernet 1/0/1
Port Trust Mode LAG
-------- --------- --------
Gi1/0/1 trust 802.1P N/A
Switch(config-if)#show qos cos-map
-----+-----+-----+-----+-----+-----+-----+----+----
Tag |0 |1 |2 |3 |4 |5 |6 |7
-----+-----+-----+-----+-----+-----+-----+----+----
TC |TC0 |TC1 |TC2 |TC4 |TC4 |TC5 |TC6 |TC7
-----+-----+-----+-----+-----+-----+-----+----+----
Switch(config-if)#show qos dot1p-remap interface gigabitEthernet 1/0/1
Port 0 1 2 3 4 5 6 7 LAG
----- ----- ----- ----- ----- ----- ----- ----- ----- -----
Gi1/0/1 0 3 2 3 4 5 6 7 N/A
Switch(config-if)#end
Switch#copy running-config startup-config
2.2.3 Configuring DSCP Priority
Configuring the Trust Mode
Follow these steps to configure the trust mode:

Table of Contents

Related product manuals