EasyManua.ls Logo

TP-Link T2600G Series - Basic Parameters Configurations; Using the GUI

TP-Link T2600G Series
1136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Managing Physical Interfaces Basic Parameters Configurations
User Guide
89
2
Basic Parameters Configurations
2.1 Using the GUI
Choose the menu L2 FEATURES > Switching > Port > Port Config to load the following
page.
Figure 2-1 Configuring Basic Parameters
Follow these steps to configure basic parameters for the ports:
1) Configure the MTU size of jumbo frames for all the ports, then click Apply.
Jumbo Configure the size of jumbo frames. By default, it is 1518 bytes.
Generally, the MTU (Maximum Transmission Unit) size of a normal frame is 1518
bytes. If you want the switch supports to transmit frames of which the MTU size is
greater than 1518 bytes, you can configure the MTU size manually here.
2) Select one or more ports to configure the basic parameters. Then click Apply.
UNIT/LAGS Click the UNIT number to configure physical ports. Click LAGS to configure LAGs.
Type Displays the port type. Copper indicates an Ethernet port, and Fiber indicates an
SFP port.

Table of Contents

Related product manuals